Below are the areas served by S&K's One Hour Air.

 

  • Aberdeen 
  • 21001
  •  
  • Bel Air
  • 21014 & 21015
  •  
  • Abingdon
  • 21009
  •  
  • Edgewood 
  • 21040
  •  
  • Joppa
  • 21085
  •  
  • Forest Hill 
  • 21050
  •  
  • Fallston 
  • 21047
  •  
  • Riverside/ Belcamp 
  • 21017
  •  
  • Havre de Grace 21078
  •  
  • Churchville
  • 21028

  

This is a small list of our regular service areas. If you are in a different, surrounding area, we will most definitely be able to serve you as well!

 

Give us a call at (410) 272-3800 and setup an appointment today (or just to say hi!).

 

We have been serving Harford County for over 30 years and look forward to serving you!

 

Here are a few things that we here at S&K's Heating and Air Conditioning provide:

 

1) Repair, Maintenance, and Installation

 

- COOLING / AIR CONDITIONING UNITS
- GAS HEATERS
- BOILERS
- HEAT PUMPS
- FURNACES

 

2) Central Heating and Air Conditioning

 

- Air Quality Control and Improvement
- Zoning
- Expansion and Alteration
- Air Flow Optimization
- Energy Savings
- Unit Change Outs

 

3) Service Plans


 - We have an extensive service 'club' that enables our customers to get high quality service and maintenance. Keep your system running like new with service like below:

 

- COOLING/AIR CONDITIONING  


Check voltage and amperage to all motors.  
Install gauges and check operating pressures.  
Check temperature across coil.    
Check for adequate charge and possible Freon leaks.
Check Pressure controls.      
Check crankcase heater.      
Lubricate all moving parts.      
Check belt and adjust tension.    
Check filters and replace (1” fiberglass only).  
Check the start capacitor and potential relay.  
Check compressor contactor.      
Check condenser coil.      
Check wiring and connections.    
Check vents and ductwork.      
Check attic ventilator/thermostat.    
Check condensate drain lines.      
Clean the exterior of condensing unit.    

 

- GAS HEAT     

 
Clean and adjust thermostat    
Clean and adjust safety controls.  
Clean the burner and controls.  
Clean and adjust pilot assembly.  
a. Check standing pilot.    
b. Check electronic ignition control.  
Check gas valve.      
Check and adjust burner for efficiency.  
Check for gas leak in unit.    
Clean the exterior of unit.    
Lubricate all moving parts.    
Check flue piping and draft.    
Check wiring and connections.  
Check manifold pressure and adjust.  
Check heat exchanger for cracks.  
Check complete heat cycle.

 

- BOILERS

(Use all gas heat checks plus:)
Check fill valve and adjust.
Clean aqua stat and adjust.
Check zone valve operation.
Check the pump operation and lubricate.
Check air elimination valve/tank.
Check operation temperature.
Check and test relief valve.


- HEAT PUMP  
    
(Use all cooling checks plus:)    
Check reversing valve.    
Check the defrost control.    
Check electrical wiring.    
Check amperage draw on each element.  
Check temperature rise.    
Check outdoor thermostat.


- FURNACE

(Use all heat checks plus:)
Check belt and adjust tension.
Clean filters and replace (1” fiberglass only).
Check fan control.
Check temperature rise.
Check voltage and amperage.